RGB Color Changing Kit with 44-Button Controller, Power Supply, and IP66 Waterproof 16.4-Feet Flexible LED Strip, 2038RGB+3315+3228

Specifications



Controller

* Input Voltage: 12VDC

* Power: 72W max.



Power Supply

* Input Voltage: 100-240V, 50/60Hz

* Output Voltage: 12VDC



LED strip

* LED Type: 150xSMD5050 RGB

* Input Voltage: 12VDC

* Power: 36W

* Length: 5m (16.4ft)




Wiring

* Unroll LED strip completely.

* Any exposed wires on the other end of the LED strip must not touch one another (or any metal object), creating a short.

* Connect the 4-pin connector of controller to that of the LED strip, making sure that the arrows line up.

* Connect 5mm DC jack of power supply to controller.

* Remove the plastic seal in the battery compartment of the wireless remote.

* Double check that all connections are correct and secure, then plug in power cord.




Note

* Avoid exposure to direct sunlight.

* Although the LED strip comes with adhesive on the back, silicone is difficult to stick to, therefore use of additional mounting hardware recommended.

* Only the LED strip is waterproof; all wires/connections and other components must be protected from the elements.

* While the included controller can handle the power requirement of two such strips, the power supply only has the capacity to drive a single strip.

* Do not lengthen the LED strip by directly connecting an additional section to it.

* Test all components before permanent installation.

* Make sure that wires at the other end of the LED strip are not touching one another (or any metal object), which would create a short circuit.

* The LED strip is cuttable every 3 LEDs, approx. every 4", at the designated cut marks.