Punch Pliers w/Gauge Guard (1.25mm) 6”

Punch Pliers w/Gauge Guard (1.25mm) 6”
- These pliers punch a 1.25mm hole in metal sheet stock up to 20 gauge. They create a smooth, clean hole without barbs or rough edges. Plus, with the gauge guard, the area around the hole will be free of unsightly indentations!
- Instructions for using the gauge guard:
- Hold the pliers shut. When properly adjusted, there should be enough space to insert your metal piece between the widest part of the pin and the bottom jaw of the pliers with a little extra room left over. If the metal doesn't fit or if there's no extra space, simply expand the jaw opening a little farther by turning the gauge guard screw to the right. (Turn right for heavier gauges and left for lighter gauges.)
- NOTE: If the adjustment screw is not properly set, you may cause damage to your pliers due to extra stress and tension on the plier jaws.
- Measurements: 6" long and 2.25" wide at the handle. The hole punch is 1.25mm in diameter and will go through 20 gauge wire or thinner.
Size: 1.25mm (1/20") BeadSmith Metal Hole Punch Pliers will punch holes in soft sheet metal (copper, gold-filled, sterling silver, and brass) up to 22 gauge. Theses hole punch pliers create a smooth, clean hole without barbs or rough edges. Plus, with the gauge guard, the area around the hole will be free of unsightly indentations. Ideal for cold connections & creating pendants. Extra-long jaws for extended reach for deep hole punches. One bonus replacement pin included.
Country USA
Brand The Beadsmith
Manufacturer The Beadsmith
Binding Misc.
ItemPartNumber PLHP125
Model PLHP125
Color Multi-colored
UPCs 790524132492
EANs 0680807516739
ReleaseDate 0000-00-00

Country	USA
Brand	The Beadsmith
Manufacturer	The Beadsmith
Binding	Misc.
ItemPartNumber	PLHP125
Model	PLHP125
Color	Multi-colored
UPCs	790524132492
EANs	0680807516739
ReleaseDate	0000-00-00

Punch Pliers w/Gauge Guard (1.25mm) 6”

You might also like...