12V Transfer Pump Extractor Oil Fluid Diesel Electric Siphon

12V Transfer Pump Extractor Oil Fluid Diesel Electric Siphon Car Motorbike

Specification:

Rated Voltage: DC 12V
Rated Power: 60W
Maximum Flow: 5L/min
Maximum Pressure: 0.8MPA
Pump Diameter: Approx. 4.8cm / 1.89inch
Length: Approx. 14.5cm / 5.7inch
Cable Length: Approx. 30cm / 11.8inch
Clips Length: Approx. 8cm / 3.15inch
Outlet PVC pipe Length:150cm
Nylon pipe Length:100cm
Brass pipe Length:70cm

Package include:

1x Oil Pump
1x 11mm Outlet PVC pipe
1x 6mm Nylon pipe
1x 5mm Brass pipe

How to use:
Â 1.Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oilÂ
2.Then connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal
3.Next,open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move; then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely); as no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again
4.After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean
If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out

Note:Â If you want to connect this pump to AC power, you will need a power converter.
Country USA
Brand CISNO
Manufacturer CISNO
Binding Automotive
ItemPartNumber FBA_CP195AC
Model FBA_CP195AC
ReleaseDate 0000-00-00

Country	USA
Brand	CISNO
Manufacturer	CISNO
Binding	Automotive
ItemPartNumber	FBA_CP195AC
Model	FBA_CP195AC
ReleaseDate	0000-00-00

12V Transfer Pump Extractor Oil Fluid Diesel Electric Siphon Car Motorbike

Customers who purchased this also purchased....