FYSETC 3D Printer Ender 3 Thermistor - Ender-3 V2 Neo Hotend Part: HT-NTC100K 3950 Temperature Sensor Cable 1M/39.3inch XH2.54 2Pin Compatible Ender 5 Pro CR6 CR10 A8 MakerPro Extruder (Pack of 3)

FYSETC 3D Printer Ender 3 Thermistor - Ender-3 V2 Neo Hotend Part: HT-NTC100K 3950 Temperature Sensor Cable 1M/39.3inch XH2.54 2Pin Compatible Ender 5 Pro CR6 CR10 A8 MakerPro Extruder (Pack of 3)

• 1. Upgrade HT-NTC100K 3950 Thermistor: Pack of 3Pcs. Note: Temperature measurement head cylinder diameter is 3mm, length 15mm, The connector is 2pin XH2.54, so make sure your heater block is the right hole, the board Connection terminal is the right type, can be used with the heating block that support the thermocouple
• 2. The temperature measurement: -20 °C ~ +250 °C for a longer lifecycle, sometimes can reach +300℃(but not recommand to use it long time)can replace the original K-type thermocouple temperature, very fit for printing high-temperature filament
• 3. Adopts 304 stainless steel, with the internal temperature package to ensure the maximum service life with precision temperature measurement.
• 4. HT-NTC100K thermistor adopts white high-temperature cord, can bear higher temperature. And for customers' convenience, the wires adopts line connection, the customer can tear the wires depends on their application. The high temperature line is double thicker than others in the market, not easy to break off
• 5. Not fit for CR-6 SE heater block