4 Pack High Density Garage Car Door Protector-Garage Wall Protector Bumper Guard for Car Doors Anti,Self Adhesive EVA Foam for Warehouse Parking Assist Collision (11.8x3.93x1.18 inches)

We have all experienced the frustration of pulling in to the garage or a tight driveway, opening our 

car door and banging the edge against the wall. It doesn't matter how gentle the opening, it inevitably

over time chips the paintwork or even dents the door edge.At the same time, pulling into a tight garage 

might mean we need to drive right up to the end wall - it doesn't take much to go just a little bit too 

far and mark the bumper.

Reinforced Adhesive

Easily install on almost all smooth surfaces including plaster, wood, metal, concrete, etc.

Excellent Multilayer Protection

Guard your car against paintwork damage when your car getting in and out of the garage.

Cuttable & Flexible

Each strip can be cut into multi pieces or different shapes.

What to do before use:

Please clean your garage wall surface firstly and ensure it is smoooth, non-dust, dry, remove any particles on it.

Measure the size and mark the places you want to put it on.

Peel off the backing paper and apply the protector on the wall, make sure it is straight and no space between it.

Repeat the same steps above for the other side of your garage wall.

Warm Tips :

Please do not put under extremely high temperature or exposure to the sun for long;

Please clean the wall surface and remove the dust or other particles and keep dry before sticking the strips to the wall;

Protectors can be removed without leaving marks on the most of the surfaces (e.g. brick, tile, glass, or marble walls). But the removal on a brittle or lime wall pavement may need to do it with care because the adhesive is very strong.