Bare Conductive Electric Paint Pen (10ml) and Paint (50ml) Combo - 1 Count

Design, discover, create. Your design and electronics projects are about to change forever. Paint and print circuits and sensors or use as a  conductive adhesive on almost anything including paper, plastic, textiles and conventional electronics

Put this flexible, revolutionary material in your toolbox today!

Works with:

Touch Board, Pi Cap, electrical components,  prototyping materials, PCBs, microcontrollers, Arduino, Raspberry Pi, MaKey MaKey and e-­-textiles. Use with the Touch Board or Pi Cap to make touch sensors.

LEVEL: Beginner to Expert Engineer

 

TECHNICAL DETAILS

Conducts electricity when dry

Paint, stencil or screen print

Air-drying

Nontoxic and solvent free

Water soluble

Paint over with water-based paints

Screen print up to 0.8m2

Dries at room temperature in 10-15 minutes

Must be fully dry to work

Easily removable with soap and water

Seal with acrylic paint or spray varnish

Can last years if treated properly and kept dry

Works on: paper, cardboard, wood, plastic, glass, plaster,some rubbers, textiles, etc...

Can be painted or sprayed over for protection or multi-layered circuitry

Can be used with conductive thread and e-textiles

Surface resistivity approx 55 ohms/square at 50 microns layer thickness

 

Extensive project examples and resources at: www.bareconductive.com/make

 

Precautions of use:

Store in a cool dry place. Use within 6 months of opening.This product has not been tested with an electrical source exceeding 12V DC or 50mA: therefore use with higher voltages is not recommended. Use in accordance with the battery manufacturer's instructions. Do not ingest. Children under the age of 14 must be supervised by an adult  whilst using this product. Can be removed with soap and water.