Blue Jeans Cable LC-2 Double-Shielded Low Capacitance

Blue Jeans Cable LC-2 Double-Shielded Low Capacitance Subwoofer Cable (White, 10 Foot)
- UNIQUE DESIGN: LC-2 isn’t a standard stock cable; we designed it specifically to optimize performance in unbalanced (“RCA”) analog audio, with coaxial geometry but with lower capacitance and better shielding than any ordinary coax.
- HEAVY SHIELDING: LC-2 is shielded with two high-coverage bare copper braids, one laid directly over the other, for the best possible performance at audio frequencies.
- HUM PREVENTION: LC-2 combats two of the principal causes of subwoofer hum: the shielding helps to exclude induced noise, while the low shield resistance lowers ground potential differences, reducing the likelihood of ground loop hum.
- LOW CAPACITANCE: LC-2’s large spacing between shield and center conductor, and the use of a highly foamed dielectric, keep its capacitance around a low 12 pF/foot.
- HIGH FLEX: LC-2 is a thick cable – but is surprisingly flexible, with a soft PVC jacket and foam dielectric.
- QUALITY PLUGS: Our Taversoe RCA plugs, gold-plated on all contact surfaces, grip the RCA jack with a circular leaf spring – providing firm engagement without jack-damaging excessive tightness.
- FROM SEATTLE, WASHINGTON: All LC-2 cable assemblies are built by American workers in our cable shop in Seattle, Washington.
Blue Jeans Cable LC-1 Subwoofer Cable, 10 foot, White:

In some ways the subwoofer cable has the easiest job of any cable in a home theater system, unburdened by high frequencies or wide bandwidth. But subwoofer applications aren't completely trouble-free, and keeping induced noise out of your subwoofer can sometimes be a challenge.

Two Braid Shields for the Ultimate in Low-Frequency Shielding Performance:

The LC-1 Analog Audio Cable, offered only by Blue Jeans Cable, was designed for the best possible performance in unbalanced consumer audio use. Two factors in cable design can affect analog audio quality: capacitance, too much of which can cause high-frequency rolloff, and shielding, which serves to keep outside EMI and RFI from getting into the signal path. LC-1 is designed for minimal capacitance (about 12 pF/ft) and for the highest shield effectiveness at analog audio frequencies. Instead of a relatively ineffective foil or spiral serve shield, LC-1 uses two high-coverage (95%) bare copper braid shields for the highest shield coverage and conductivity. This provides the best rejection of low frequency hum and noise possible in an unbalanced analog audio cable.

Taversoe RCA Plugs for High Durability and Contact Integrity:

The RCA plugs are our Taversoe 7 model, designed specifically to fit LC-1. These are a three-piece crimp plug, not a simple solder or compression plug, and are designed to endure flexing and pulling without coming apart. The center pin and the outer contact are gold-plated, and the outer ring uses a series of miniature leaf springs to grip the jack for a secure but not overly-tight fit.

Assembled in the USA by American Workers:

The cable stock is made for us in Richmond, Indiana, and connectorization is done right here in our Seattle, Washington assembly shop by American workers using precision stripping and crimping equipment.

Country	USA
Brand	Blue Jeans Cable
Manufacturer	Blue Jeans Cable
Binding	Unknown Binding
ItemPartNumber	BLC1S10W
Model	BLC1S10B
Color	White
Size	10 foot
UnitCount	1
UPCs	811887012693
EANs	0811887012693
ReleaseDate	0000-00-00

Blue Jeans Cable LC-2 Double-Shielded Low Capacitance Subwoofer Cable (White, 10 Foot)

You might also like...