Camshaft Position Sensor Replacement for 12584079 / PC403 / 213-1557, 3‑Pin Hall‑Effect Sensor with O‑Ring, Plug‑and‑Play Direct Fit for Compatible Vehicles (Verify Part Number/VIN)
Sold Out / Out of Stock
Camshaft Position Sensor Replacement for 12584079 / PC403 / 213-1557, 3‑Pin Hall‑Effect Sensor with O‑Ring, Plug‑and‑Play Direct Fit for Compatible Vehicles (Verify Part Number/VIN)
DIRECT-FIT COMPATIBILITY: Designed to match OE 12584079 / PC403 / 213-1557 with the correct 3‑pin connector geometry for vehicles that use a Hall‑effect cam reference signal. Compare your original sensor and part number (or VIN fitment) before ordering—this is fitment‑specific and is not a universal sensor.
HELPS ADDRESS COMMON DRIVEABILITY SYMPTOMS: A failing cam sensor can contribute to a Check Engine Light and cam sync fault codes (including P0340), long crank, rough idle, hesitation, or intermittent stalling. Replacing a worn sensor restores a stable cam timing signal used for fuel/spark control, helping your engine run more consistently when related symptoms are present.
PLUG‑AND‑PLAY DIY INSTALL: Built for a straightforward replacement—disconnect the harness, remove the fastener, swap the sensor, and reconnect (no splicing or rewiring). The included O‑ring seat supports a tight seal at the mounting point. Basic hand tools are typically sufficient; allow the engine to cool and work in a well‑lit bay.
STABLE SIGNAL & DURABLE BUILD: Hall‑effect design delivers consistent output under heat and vibration, with a heat‑resistant housing and sealed connector to support dependable performance in daily driving. Built to handle under‑hood conditions for commuters, fleet vehicles, and routine maintenance where reliability matters.
IMPORTANT LIMITATIONS & NOTES: Not for crankshaft position sensor applications or vehicles with non‑matching connectors/modified harnesses. If a fault code remains after installation, inspect wiring, connector seating, and related components. If you’re not comfortable working under the hood, consider professional installation to avoid misalignment or damage.