DICN Scissor Car Jack 2 Ton Steel with Chromed Handle for Roadside Tire Change Repair, Black 1 Pcs

Package included:
Scissor jack x 1
Handle x 1

Specification:
Condition: Brand new
Minimum height: about 105MM
Maximum height: approximately 385MM
Lifting: 2T
Color: Black
Material: Steel
Net weight: 2.1KG
Item Size: 41*8.8*9CM

HEIGHT/CAPACITY CURVE
This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position.
Before Use
1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts.
2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock.
3. If the jack is found to be damaged, it should be removed from service until properly repaired.

OPERATING INSTRUCTIONS
1. Insert the jack handle into the hole of the handle socket.
2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket.
3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise.
4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly.

CARE AND MAINTENANCE
1. When jack is not in use, lifting arm should be in full down position.
2. Always keep jack clean and keep the screw and bearings well lubricated.
3. Store the handle with care.