ARTMAN INSTRUMENTS Braces Wire Cutter Orthodontic Distal End Cutter, Large Handle, Tungsten Carbide Inserts with Safety Hold, For 0.014" to 0.019×0.025" Wires

ARTMAN INSTRUMENTS Braces Wire Cutter Orthodontic Distal End Cutter, Large Handle, Tungsten Carbide Inserts with Safety Hold, For 0.014" to 0.019×0.025" Wires

• PLEASE NOTE BEFORE PURCHASING: This cutter is not designed to cut very thin steel wires and thin flexible nickel titanium wires that are used at the initial stages of braces. It is used only for thick wires of a diameter of 0.014 to 0.019X0.025 inches.
• Very Important: Align the tip properly with the wire (See the picture below) otherwise either the wire will bend or the tip will break.
• EASY TO CUT THE BRACES WIRE: If the braces wire pokes to your cheek at the end, this pliers is the solution. Just engage the wire and cut it in a second. When you use these pliers it will also hold the cut-off part and will not let it to injure the cheek.
• MORE VISIBILITY IN USE AND SOFT EDGES: The cutting area remains more visible because of its small cutting edges. The edges are smooth and will not hurt the cheeks or lips.
• EASY TO CLEAN: The 100% stainless steel construction makes the wire cutter easy to clean and they can be fully autoclaved without fear. It is a safe and hygienic choice for medical procedures.
• THESE PLIERS ARE NOT DESIGNED FOR THE CUTTING OF VERY THIN WIRES. WIRES LESS THAN 0.014" DIAMETER ARE NOT RECOMMENDED TO CUT WITH THESE PLIERS.
• Intended for cutting thicker orthodontic wires from 0.014" up to 0.019×0.025". Not suitable for very thin wires below 0.014" diameter or thin flexible nickel titanium (NiTi) wires used in initial stages of treatment.