Duck Brand Indoor/Outdoor Fiberglass Double-Sided Carpet Tape: 1.88 in. x 75 ft. (White)

Duck Brand Indoor/Outdoor Fiberglass Carpet Tape is a double-sided fiberglass tape used for permanent carpet installation. Fiberglass is moisture and mildew resistant so it is ideal for high traffic areas where moisture is a problem such as bathrooms, basements and decks. For both indoor and outdoor use. Since this tape is for permanent installations removal could cause damage to not only the floor but also to the carpet.

Instructions To Apply Double-Sided Fiberglass Carpet Tape

• Thoroughly clean and dry floor surface.
• Apply tape, liner side up, pressing firmly to floor.
• Roll or fold one half or carpet cut to fit area back over itself. Remove tape liner, then roll or fold carpet back down to floor, pressing firmly for good adhesion.
• Then repeat for the other half of carpet.

Made in the U.S. If not otherwise specified widths shown in dropdown are in inches. NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 48mm wide. As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first.

Technical Information• Core: 3 inch diameter
• Backing/Carrier: fiberglass
• Adhesive: rubber based
• Release Liner: white paper
• Thickness: 6 mils (carrier, adhesive)
• Adhesion: 75 ounces per inch (to stainless steel test panel)
• Tensile Strength: 150 pounds per inch (longitudinal)
• Application Temperature: 50F to 120F
• Service/Operating Temperature: up to 200F
• Elongation: 7 %