E-Style External Retaining Ring, Tapered Section, Radial Assembly, 15-7 PH Stainless Steel, Passivated Finish, 3/16" Shaft Diameter, 0.025" Thick, Made in US (Pack of 25)

The E-style external retaining ring has a tapered section, assembles radially, is made of passivated 15-7 PH stainless steel, and is made in USA. The ring's E-style shape has three points of contact with the shaft for retention when installed. The tapered section style provides the ring with flexibility to facilitate installation and typically withstands higher thrust loads than constant section and spiral rings. The ring installs by sliding it onto a shaft from the side, also called radial assembly. Often used when the shaft end is not reachable, radial assembly rings enable quicker installation than axially installed rings but may require deeper grooves. The 15-7 PH stainless steel grade offers high strength and hardness, and maintains its corrosion resistance in high temperatures, and the passivated finish enhances its corrosion resistance of stainless steel.

Retaining rings attach to a shaft (external) or install in a bore (internal), creating a shoulder to maintain component positioning within an assembly. While most rings install into a machined groove either on the inside or outside diameter of a shaft, self-locking rings attach to a shaft by using friction from means such as teeth and notches to maintain placement. Retaining rings should fit tightly enough into the groove or onto the shaft so they won't experience any movement.