Extra Remote Control for EKYLIN Remote Battery Switch Disconnect System DC 12V

Extra Remote Control for EKYLIN Remote Battery Switch Disconnect System DC 12V

• Extra remote control for EKYLIN Remote Battery Switch Disconnect System DC 12V
• Please notice that: the additional remote is not preset to pair with the current receiver, you need follow the steps to pair the remote control with the receiver :
• 1. Hold the pairing button for 5 seconds to re-set the receiver working mode. While holding the button for 5 seconds, don't release the button until the red light flash 3 times. This is to set the working mode for 2 button control mode.(very important)
• 2. Hold the pairing button (less than 5 seconds) until the red indicator light on. Then press the remote control button (any one of on / off), the reciever will learn the signal code and pair with it.
• 3. If the red indicator light is off, then the pairing is ok.(The previous remote control can still work because the receiver can save upto 20 remotes' codes)