Glen Martin H-4 Super Heavy Duty Steel Hazer Tram System for

Glen Martin H-4 Super Heavy Duty Steel Hazer Tram System for ROHN 20/25G Towers
- Model: H-4 For Tower Model: ROHN 20/25G
- Heavy Duty Galvanized Steel Dead Weight Load: 200 lbs / Wind Load Ability: 16 sq ft @ 87 mph / Wind Load Capacity: 14.4 sq ft @ 80 mph, 12 sq ft @87 mph
- Dimensions: 44" H x 15-1/4" W Weight: 49 pounds
- Includes: Top & bottom plates for rotor and thrust bearing. Standard winch (W-1101) 100' of 1/8" winch cable (for a 50' tower), Top pulley, All mounting hardware (stainless steel)
- Never climb your tower again! *Signature Required at Delivery*
ADDITIONAL REQUIREMENTS: Towers over 50' require additional cabling Towers equipped with a TailTwister rotor require a HR-6010 TailTwister plate Visit our store for more Hazers and Hazer Accessories How does it work? The Hazer works like a simple elevator designed to easily raise and lower your antennas, measuring instruments, rotators, etc. The Hazer is designed to wrap around the tower. A pulley at the top of the tower, along with a winch and wire rope is used to raise and lower the antenna. It's as simple as raising a flag up a flag pole. No Climbing! The Hazer makes servicing your antennas a cinch, even with one person! May guy wires be used with the Hazer? A fifty foot tower will require only one set of guy wires in most cases. We suggest putting these guys at the very top of the tower in the few inches just above the Hazer. To lower a beam antenna, disconnect two guys by completely unscrewing the turnbuckles at the ground. The guys then will drape in toward the tower. The Hazer can then be lowered to the ground. Once down, the guys can be reconnected. Imagine having a completely guyed tower with your antenna system parked at ground level. Never worry about storms again! Is it easy to install? The Hazer is easily assembled on an erected tower; however, some climbing is necessary to install the pulley block assembly and winch cable. If it is installed before the tower is erected, no climbing is required. Once installed, the Hazer travels smoothly past tower braces and section joints.

Country	USA
Binding	Electronics
Brand	Glen Martin
EAN	0636134503553
Label	Glen Martin
LegalDisclaimer	Manufacturer nor seller will not be liable for loss or damage to property or any incidental or consequential loss or expense from property damage due directly or indirectly from the use of these products.
Manufacturer	Glen Martin
Model	H-4
MPN	H-4
PartNumber	H-4
Publisher	Glen Martin
Studio	Glen Martin
ReleaseDate	0000-00-00

Glen Martin H-4 Super Heavy Duty Steel Hazer Tram System for ROHN 20/25G Towers

Customers who purchased this also purchased....