HWAYEH for Arduino Nano V3.0, Nano Board CH340/ATmega328P 5V 16M Micro-Controller Board with USB Cable, Compatible with Arduino Nano V3.0 (Nano x 1 + Cable)

HWAYEH for Arduino Nano V3.0, Nano Board CH340/ATmega328P 5V 16M Micro-Controller Board with USB Cable, Compatible with Arduino Nano V3.0 (Nano x 1 + Cable)

• The Arduino Nano is a compact board similar to the UNO.The Arduino Nano is a small, complete, and breadboard-friendly board based on the ATmega328P (Arduino Nano 3.x). It has more or less the same functionality of the Arduino Duemilanove, but in a different package. It lacks only a DC power jack, and works with a Mini-B USB cable instead of a standard one.
• Each of the 14 digital pins on the Nano can be used as an input or output.They operate at 5 volts. Each pin can provide or receive a maximum of 40 mA and has an internal pull-up resistor (disconnected by default) of 20-50 kOhms. In addition, some pins have specialized functions
• Nano's got the breadboard-ability of the Boarduino and the Mini+USB with smaller footprint than either, so users have more breadboard space. It's got a pin layout that works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other).
• Suitable for DIY enthusiasts to develop and use school textbooks，The Nano is using the chips ATmega328P and CH340, not FT232 as official Arduino
• Microcontroller ATmega328P Operating Voltage (logic level) 5 V Input Voltage(recommended) 7V-12V Digital I/O Pins 14 (of which 6 provide PWMoutput) Flash Memory 32 KB (ATmega328) of which 2 KB used by bootloader