Mini Heat Gun, 300W Dual Temperature Hot Air Gun (110V) with 6.6ft Long Cable & Reflector Nozzle - Ideal for Epoxy Resin Crafts, Shrink Wrapping, Embossing & Vinyl Wrap (‎MF300 Constant Temperature)

Features:

100% Brand New and High Quality ABS and PC plastic material, it equip with the stainless steel bracket to rotate 100 degress. It is Very compact and durable, practical

Keeping 5-6cm distance from work and about a 45 degree angle to heat until it is completed. It not only can add its hardness, but also its brightness

There are heat vents in left and right sides to decreased the internal temp and extend its lifetime

This excellent compact heat gun can be used for heating shrinkable film, embossed powder,rubber stamp, the best choice to replace toaster or oven and the polymer clay will become hard and bright after using the gun

The temprature can not be adjusted, but in theory, it can reach at about 200 degree within a few seconds abstractly. But do not use it more than 10 minutes, just you can turn off then turn on again for working continuously

Specification:

Material: Plastic ABS+PC

Cable length: 6.56FT /180 cm

Rated Power: 300W

Rated voltage:110v

Power: 50-60Hz 

Working time: 8 minutes

Power type: AC power supply

Type: Constant temperature

Attention:

-Do not touch with water! Do not touch the hot nozzle.

-Do not use outdoor. Keep it out reach of children. Keep 5-6cm distance between the heat tool and itrm.

-Do not use more than 10 minutes continuously to prevent overheated.

-This hot air gun is specially made for DIY, it can't not use in industry aspect

Package includes: 

1 x Hot Air Gun