Icstation DC12-30V ZVS Tesla Coil SGTC Marx Generator High

Icstation DC12-30V ZVS Tesla Coil SGTC Marx Generator High Voltage Driver Plate Board Arc Igniter Induction Heating Power Module no Taps
- Icstation zero voltage switching (ZVS) tesla coil flyback driver board with high power output up to 300W, support DC12-30V input and current should be over 10A, igh voltage output ideal for DIY spark gap tesla coil (SGTC), Jacobs ladder and Marx generator, etc.
- Large inductor of stable performance parameter, 30mm big magnet ring, 1.2mm pure copper wire; the bottom of circuit board high current part is soldered, all resistor adopt five ring tight resistor
- Adopt 1.6mm double side fiber glass board, size: 90x90mm/3.54"x3.54" (L*W)
- Other driving is immeasurably, the higher the voltage the longer the arc, personally test with 27V/ 15A switching power supply can pull more than 80MM arc, basically no heat; can also be induction heating or quenching, this is also The higher the voltage the faster the heating, while the greater the heat, it is recommended to heat the solid object diameter does not exceed 2/3 of the coil.
- Ship out by USPS with tracking information and 7-17 days delivery time usually
A flyback drive circuit, which is used to drive the ignition coil, as did the Zero Voltage Switching, masses of fans called them "ZVS circuit". Because of its big power, low heat, simple and reliable by fans are widely used in the drive spark gap tesla coil (SGTC) and Jacob, ladders, Marx generator, etc.This ZVS driver kit support DC 12-30V voltage input and high voltage output up to 800 times of the input votlage with high arc generated up to 5cm ideal electricity science experiment.

Specifications:
Input Voltage: DC 12-30V
Input Current: >5A(under 12V), >10A(over 15V)
Working Frequency:30-50KHz
Arc Length:2-8cm(depens on power supply)
Board Size: 90 X 90mm/3.54 X 3.54inch(L*W)

Package Included:1X ZVS Flyback Driver Board

Warm Tips:
1. The power supply should at least 12V 5A,if the power supply is too low lead to the low power input, then the two MOS will connect at the same time, this will damage it. (when use the induction heating function, the power supply suggest 24V 15A)
2. When there is no loads connected, please do not power on the module, otherwise it will produce high frequency noise to damge the MOS.
Country USA
Brand IS
Manufacturer Icstation
Binding Electronics
ItemPartNumber 1175001
Model ZVS Driver Board
Color Black
UnitCount 1
ReleaseDate 0000-00-00

Country	USA
Brand	IS
Manufacturer	Icstation
Binding	Electronics
ItemPartNumber	1175001
Model	ZVS Driver Board
Color	Black
UnitCount	1
ReleaseDate	0000-00-00

Icstation DC12-30V ZVS Tesla Coil SGTC Marx Generator High Voltage Driver Plate Board Arc Igniter Induction Heating Power Module no Taps

You might also like...