Juki Binder Foot for HZL-DX and HZL-G Series Machines

Juki Binder Foot for HZL-DX and HZL-G Series Machines

The Bias Tape Binder snap-on foot allows for bias tape to be easily added to finish an edge. This versatile foot can also be used to create button loops, frog closures, and is a great construction tool for reversible garments. The spiral cone on this foot wraps the bias tape (pre-folded or not) neatly around the edge of the fabric. Straight stitch patterns are generally used to with this presser foot, but decorative patterns can be used to create a unique effect. Attach the bias binder to the presser foot holder. Guide one end of the bias tape into one of the five slots on the foot, based on the width of the tape. Figure 1 A tape width of 2.2mm should go into the largest slot on the foot. Pull the tape from the inside of the guide, using a sharp instrument, such as tweezers or a stiletto. Place the tape behind the presser foot. Figure 2 Check that both sides of the tape are folded completely inside, when the tape is pulled behind the presser foot. Adjust the needle position so that the needle is stitching through the bias tape. If the needle position cannot be changed, use the screw on the foot to adjust the cone to the right or to the left, as needed. Figure 3 Begin sewing at a slow to medium speed, gently guiding the tape to keep it properly aligned with the fabric. TIPS: To more easily maneuver fabric into the cone, use the points of the tweezers or a stiletto and gently push the fabric into the cone. Clipping the corner of the tape at a 45 degree angle can make tape insertion, into the cone easier. Fits Juki Models HZL-DX 2000QVP HZL-DX7 HZL-DX5 HZL-F600 HZL-F400 HZL-F300 HZL-G120 HZL-G220 HZL-G210 HZL-G110
Country USA
Brand JUKI
Binding Kitchen
UPCs 721802488291
EANs 0721802488291
ReleaseDate 0000-00-00

Country	USA
Brand	JUKI
Binding	Kitchen
UPCs	721802488291
EANs	0721802488291
ReleaseDate	0000-00-00

Juki Binder Foot for HZL-DX and HZL-G Series Machines

You might also like...