Lutron Maestro PRO LED+ Tap Dimmer Switch for 250W LED, 500W ELV, 400W MLV, Single Pole/Multi-Location, Neutral Wire Optional, MA-PRO-WH, White
Product Description
Lutron Maestro PRO LED+ Tap Dimmer Switch for 250W LED, 500W ELV, 400W MLV, Single Pole/Multi-Location, Neutral Wire Optional, MA-PRO-WH, White
- Maximum rating: 250-Watt LED, 500-Watt incandescent/halogen/ELV, 400-Volt Amp MLV or 20 Hi-Lume 1% 2-wire (LTE) LED drivers
- Neutral optional for LED, CFL and incandescent/halogen, neutral required for ELV, MLV, dimmable fluorescent ballasts and Hi-Lume 1% LED drivers
- Single pole or multi-location dimming from up to 9 locations with companion dimmer (MA-R-xx sold-separately)
- Advanced programming mode allows users to customize the controls preset light level, high- and low-end trims, disable indicator lights, fade times and phase select
- Phase auto-select: chooses between either reverse or forward phase (when neutral is connected the automatic default is reverse phase, when neutral is not connected, the automatic default is forward phase)
- Power failure memory, should power be interrupted, the control will return to it's previous state when power is restored
- Screw terminals for easy install, can be installed on either load or line side of circuit
- While load is on: green indicator lights brighten and reflect light level, when load is off: indicator lights remain in a soft glow state
- Maestro pro LED plus dimmers and wall plates are available in 10 plus colors (wall plate sold separately)
Power failure memory: Should power be interrupted, the control will return to its previous state when power is restored. Tested to withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits. Tested to withstand electrostatic discharge without damage or memory loss. For 3-way and 4-way dimming, use Maestro Companion Dimmers. One dimmer can be used with up to 9 multi-location companion dimmers. Total multi-location wire length (blue wire) between all units must not exceed 150 ft (45 m). Includes a Front Accessible Service Switch (FASS) for safe bulb replacement. Application Requirements When using LEDs or CFLs, only bulbs marked or rated as Dimmable can be used. For a complete list of approved DIMMABLE LEDs and CFLs please visit www.lutron.com/ledfinder
