MakerFocus 2pcs 3.7V 3000mAh Lithium Polymer Rechargeable

MakerFocus 2pcs 3.7V 3000mAh Lithium Polymer Rechargeable Battery 1S LiPo Battery with Protection Board Insulated Rubber Tape and JST 1.25 Plug for ESP32 Development Board, Mesh Node T114
- Charging Method: The recommended charging current is 0.6A, the maximum does not exceed 1.5A. The discharge current is recommended 0.6A, and the maximum does not exceed 1.5A
- Overcharge Protection: When charging the battery, when the voltage reaches the highest battery voltage (4.2V), the protection board will automatically power off and shut down, indicating that it will not continue to charge when fully charged, forms overcharge protection
- Over-discharge Protection: When the battery is about to run out and the voltage is as low as 3.0V, the protection board will also be turned off and can no longer be discharged, forming an over-discharge protection effect
- Short Circuit Protection: When an accidental short circuit occurs, the protection board will automatically shut down within a few milliseconds and will not be powered on again. Note that the cell is short-circuited (not through the protection board). The protection board will also fail due to continuous high current, or the components are heated and damaged
- Note: The battery overcurrent protection is not a panacea, do not continue to charge and discharge the current and voltage with a large current beyond the range, otherwise the protection board will be damaged and invalid
Country USA
Brand MakerFocus
Manufacturer MakerFocus
Binding Electronics
Model MF-3100-LP
Warranty No Warranty
Size 2
UnitCount 2
ReleaseDate 0000-00-00

Country	USA
Brand	MakerFocus
Manufacturer	MakerFocus
Binding	Electronics
Model	MF-3100-LP
Warranty	No Warranty
Size	2
UnitCount	2
ReleaseDate	0000-00-00

MakerFocus 2pcs 3.7V 3000mAh Lithium Polymer Rechargeable Battery 1S LiPo Battery with Protection Board Insulated Rubber Tape and JST 1.25 Plug for ESP32 Development Board, Mesh Node T114

Customers who purchased this also purchased....