Mophorn Water Chiller 6L Capacity Industrial Water Chiller CW5000DG Thermolysis Type Industrial Water Cooling Chiller for 80W to 100W Laser Engraving Machine (CW5000DG)

Industrial Water Cooling Chiller for CO2 Laser Tube Engraver Cutting Cutter CW5000 DG

Introduction :

The CW-5000DG Chiller is popular for cooling CNC and Laser machines.It is designed for cooling the one CO2 glass laser tube under 80W/100W of the laser engraving and cutting machine. Emitting rate higher than 60%.Under normal circumstance,the new intelligent temperature controller does not need to adjust the controlling parameters.

Technical Data

Voltage:110V

Frequence: 60HZ

Current: 3.5~5.6A

Tank Capacity: 6L

Compressor Power: 0.305KW, 0.41HP

Refrigerating Capacity: 2866Btu/h, 0.84KW, 722Kcal/h

Refrigerant: R-134a

Refrigerant Charge: 280g

Precision: ±0.3℃

Reducer: Capillary

Pump Power: 0.03KW

Maximum Flow: 10L/min

Maximum Pumping Lift: 10M

Inlet and Outlet: External Φ10mm brass connector

Protection: Flow alarm

Install steps:

A.Open the package to check if the machine is intact and all the necessary accessories are completed

B. Open the injection port to feed cooling water

C. According to system conditions, please well connect water inlet and outlet pipe

D. Plug in, turn on the power switch. (Do not start up without water in the tank!)

E. Check the water level in the water tank

F. Adjust parameters of temperature controller

1.±0.3℃ precisely temperature control

2.800W cooling capacity; use environmental refrigerant

3.Compact size, long working life and simple operation

4.The intelligent temperature controller has 2 control modes, applicable to different applied occasions; with various setting and display functions

5.Multiple alarm functions: compressor time-delay protection, compressor overcurrent protection, water flow alarm and over high / low temperature alarm