Mosaic Pin Pins Knife Handle Custom Knives Blank Blades Brass Copper Steel for Hunting Knives (3/16") (#20 (3/16"))

Mosaic Pin Pins Knife Handle Custom Knives Blank Blades Brass Copper Steel for Hunting Knives (3/16") (#20 (3/16"))

• Our mosaic pins are hand-crafted by a veteran knife-maker in the USA.
• Diameter: 3/16", Length: 5.8 inches approximately. You get 1 piece of mosaic pin stock with each order. For knife handles.
• If your knife handle is 0.75"-0.9" thick, this mosaic piece will make 6 pins when cut (good for several knives). If your knife handle is 0.95"-1.15" thick, this mosaic piece will make 5 pins when cut (good for several knives). If your knife handle is 1.2"-1.4" thick, this mosaic piece will make 4 pins when cut (good for several knives).
• Our mosaic pins have been vacuum-pumped to remove air bubbles. The resin is pulled in with a high-end vacuum, which pulls the glue down, and removes any small bubbles. The pins are cured afterward and lastly polished and burrs removed.
• You wont get any "rattlers" with our high quality mosaic pins (a "rattler" is where you have loose pieces inside the mosaic pin due to inadequate vacuum pumping out of air bubbles prior to the curing stage).