Lakco Nimrod Ice Auger Adapter - Converts Hand Auger to Power Auger - Made in USA - #TONII - for Pin System Augers

Nimrod Ice Auger Adapter - Fits Mora & Lazer Strikemaster Auger & the Eskimo auger - Works Best With Nimrod SmartHandle - Just for new pin system augers, not a threaded handle - It is loose on the HT auger and is not recommended. - 8-3/4" long - 3/4" chuck where you connect auger drill - 3/8" chuck where you connect drill - Convert your hand auger into a power auger using a cordless drill! - Works with 3/8" or 1/2" cordless drill - Cuts up to 50 holes on a single battery charge - Cuts through 10" of ice in about 8 seconds - Three-sided arbor prevents spinning - Made in Michigan for Lakco - An amazing product!!! - A must for the Ice Fisherman!!! - You can use any 18 volt cordless drill (or larger 19.2 is also good), does not matter what brand, but has to be 18 volt (or larger), not 12 or 14 volt. (NOT recommended for lower than 14.4 volt drills.) - NOTE: This is for adapter only, auger & drill are not included! This is only so you know how it works! - NOTE: We have sold about 5000 of these over the past 7 years and only 3 people lost their augers. All three were when the guys put the drill in reverse; this loosens the drill bit. - **DO NOT flip from Forward to Reverse to back auger out of hole!!!** - DO NOT PUT DRILL IN REVERSE: PULL AUGER & CHUCK UP!!