OTC 7073A Heavy-Duty Truck Clutch Alignment Tool - 10-Spline, 1-3/4" OD, 1-1/4" Pilot
Product Description
OTC 7073A Heavy-Duty Truck Clutch Alignment Tool - 10-Spline, 1-3/4" OD, 1-1/4" Pilot
- OTC's 10-Spline Truck Clutch Alignment Tool is designed for use when installing heavy-duty single, two-plate, push/pull, manual, and self-adjusting clutches
- Tool is constructed of lightweight fiberglass-reinforced nylon that won't hang up in clutch disc splines
- Rugged construction will easily support the weight of heavy clutch discs
- To use, loosely install clutch disc and pressure plate on flywheel then insert alignment tool through the clutch into the bearing, center disc, then tighten pressure plate to spec
- 1-3/4 inch O.D. shaft, 1-1/4 inch pilot, 10 splines, splines are 3.75 inches long; similar to Ford 308-D002 (D79T-7550-B)
The OTC 7073A is designed for use on heavy-duty single two-plate push/pull manual and self-adjust clutches. The shafts are constructed of lightweight fiberglass-reinforced nylon that won’t hang up in clutch disc splines. Yet they’re rugged and will easily support the weight of heavy pressure plates.
Technical Specifications
You might also like
OTC 7480 1-3/4" O.D. Truck Clutch Aligning Shaft
OTC (7074A) Truck Clutch Alignment Tool - 2" O.D.
OTC (7072A) Truck Clutch Alignment Tool - 1-1/2" O.D.
Ingersoll Rand 285B-6 Heavy Duty Pneumatic Impact Wrench with 6-Inch Extended Anvil, 1 Inch
OTC 5019A 2,200 lb. Capacity Low-Lift Transmission Jack
OTC 1909 3-1/4" 8-Point Octagon Locknut Wrench
OTC 5030 1-3/4" OD Truck Clutch Aligning Tool