T10 194 168 W5W LED Canbus Decoder, Anti-Flicker Error Free Resistor Adapter (Pack of 2)

1)T10 LOAD RESISTOR FOR FIXING THE BLINKING OF LED/HID IN AUTO(CAR/MOTORCYCLE/SCOOTER) SIGNAL LIGHT BULB
Make sure the prongs positions are correct to your application cause some applications the prongs are twisted
2)NOTICE IN THIS PRODUCT :

FLASH SPEED FOR SIGNAL/TURN LIGHT APPLICATION--
Normally when you flip your turn signal switch, the light blinks at a set, slow pace.
However, if you have modified your lights to use LEDs, you'll notice that the turn signals
now blink very quickly (Hyper-Flash). This is caused by the low resistance of the LEDs due to
the fact that they use less power. To correct the problem, you'll need to wire the turn signals
in a parallel circuit. To do this, you'll be installing a resistor or control flasher.
DASH INDICATORS MISJUDGING BURNT OUT BULBS--
The purpose to use LED is energy saving.
LED bulbs may cause some newer(Mercedez, BMW, AUDI, VW, ...etc. Most are CAR-COMPUTER built in design) vehicles
to indicate a bulb as burnt out (the truth is that the computer is disable to detect the bulb because of their low power consumption).
Except the Hyper Flashing in signal/turn light, some turn on a bad bulb indicator also happens.
The only fix for this is to install Load Resistors across the bulbs that are being indicated as bad.
Some vehicles will also disable the cruise control system if a brake light bulb is being indicated as bad,
the installation of Load Resistors is a general solution.
HIGH OPERATION TEMPERATURE--
Load Resister is HOT when users turn on the light, please DON'T mount on the plastic and try to leave away from similar materials.