PGEAR 20Hz GPS P610 Based Performance Meter Box with Mobile App, Car LapTimer and Drag Meter, Racing Accelerometer

This is a new generation laptimer , not only can measurement cars performance but also let them upload the results , compare discuss with eachothers.

1.Reminders
Please check all accessories when opening the package：
One P-Gear
One charging cable
Two sets of stainless iron plates & 3M mounting tapes

2.Caution
Underneath the P-GEAR logo is the GPS receiver antenna. Please keep the logo pointing upward to the sky at all time (very important). Do not block the device from GPS signals with any metal objects or window films that contain metal. Any blockage may result in GPS data inaccuracy.

3.Device Binding
1: Turn the switch on, turn the smart phone application on and set Bluetooth to "On" .
2：Press "GO" in the App, choose any test mode, and a Bluetooth connection window pops out. Choose a valid P-Gear, connect and bind the device. (Attention: DO NOT connect the device in system's Setup)
Attention：During the binding process, an error message, "Not official device", may pop out. This error is incurred because the device number is not yet registered in the system, or the device is not a legitimate official device. Please contact our customer service and our staff will assist you ASAP.

4.Testing Modes
Drag Race Mode、Track Modes、vido mode、contest

5.Trouble Shooting
1：When charging, the red Charging Light is illuminated constantly and goes off when fully charged;
2：When the Bluetooth is connected, the blue light will be illuminated constantly. A flashing blue light indicates no Bluetooth connection.
3：The green GPS blinks when positioning is done. If the green light does not flash, please drive to open areas and wait 3-5 minutes and the light will blink;
4：Do not test when the GPS readings are fluctuating. Wait until the readings stabilize.