PYRAMID Mold for Plaster 3D Decorative Wall Panels, 1 pcs ABS

PYRAMID Mold for Plaster 3D Decorative Wall Panels, 1 pcs ABS Plastic mold
- Our molds for 3d panels are made of impact-resistant ABS plastic
- Suitable for home casting and business.
- Ideal geometry, shapes perfectly interlocked with each other
- The period of exploitation is 200-500 gypsum castings.
- Low cost of finished gypsum 3 d panel
Form for the manufacture of 3d panels, 3d tile is universal for interior and exterior. It can be used for finishing walls, ceilings, columns and other architectural structures. Wall panels made of gypsum will make your interior individual and refined.
At us you can buy forms from ABS plastic and independently make 3d panels from gypsum or concrete.

How to make 3d panels?

1. Not necessary (but recommended). Make a frame (wooden is ok) under the mold so that you can tightly fix your mold on the surface.
2. Lubricate the mold (especially in deep places and corners). You can use special greases or something like vaseline (petrolatum).
3. Make mixture with ratio shown in the spreadsheet at the top and fill the mold. Tap the mold slightly several times to remove air from mixture.
4. After about 3-5 min you can feel that plaster got warmer, after this wait about 15 min and bend the edges one by one, carefully turn the mold upside down and take it off from panel.
5. Look at the panel edges and remove bevels with putty knife if they appeared.
6. Leave panel to dry in a warm place (face side down or in vertical position).
7. Also you can already mount them on wall without waiting for drying because gypsum does not shrink.
Country USA
Manufacturer ArtMolds
UPCs 600300976854
EANs 0600300976854
ReleaseDate 0000-00-00

Country	USA
Manufacturer	ArtMolds
UPCs	600300976854
EANs	0600300976854
ReleaseDate	0000-00-00

PYRAMID Mold for Plaster 3D Decorative Wall Panels, 1 pcs ABS Plastic mold

You might also like...