Screen Replacement for iPhone 7 Plus, LCD Display and Touch Screen Digitizer Replacement Full Pre-Assembly with Proximity Sensor,Ear Speaker,Front Camera and Repair Tools (Black,5.5)

Attention Please

Refer to the installation tutorial on Youtube (Related Video Shorts)

Test the screen by inserting the flex to the main board before installation; be sure you feel a gentle snap. If not, try again.

Confirm the phone is power off before installation.

Do not press the left and upper corners of the screen, otherwise may cause lines on the screen.

Each screw should be installed into original location, because they are not same length! Never tighten screw over limit!

Treat flex cables gently, use tools instead of your finger during installation , otherwise the screen will damage!

If you meet with these issues

Cannot turn on, touch insensitive, flash, lines on screen, ghost click etc.

Please try this: Power off your phone, disconnect all the cables including the battery cable, clean the connector on the motherboard, reconnect the cables, leave the phone alone for a while in a dry environment, a hard reset of your phone power on.

Package Including:
LCD Assembly for iPhone 7 Plus *1 (4.7 inch)
Screen Protector*1 (HD Clear Protective Film)
Repair Tools Kit*1
Manual Instruction