TECHTONGDA Lens Grinder Hand Lens Edger Eye -Glasses Hand

TECHTONGDA Lens Grinder Hand Lens Edger Eye -Glasses Hand Edger With V-groove 110V Manual Lens Edger Polisher Grinding Single Wheel Grinder Optical Hand Stone
- Parameters: Diamond grinding wheel material:Grinding wheel size: 100 * 100 * 35 mm; Product size: 285 * 170 * 225 mm;110V 55W;The grinding wheel speed: 5500-6000 r/min;
- Optical lens edger design:The coarse grinding, fine grinding, grinding groove;The water yield,can be adjusted;Diamond grinding wheel, durability;Double brace,higher stability;5.Remove the sink,1t's easier to change water;
- Features:Single Wheel; 35WV type grinding wheel: Width 35 mm, right rough grinding 16 mm, left fine grinding 19 mm, edge truing groove;Double holder; the diameter of the grinding wheel is 3.5cm/1.38inch.
- Double water tank:Equipped with two upper and lower water tanks, both of which can be disassembled. The upper water tank is equipped with a water volume regulating valve to control the water spraying speed. The water spray valve is made of pure copper and is durable. The drain is connected to a drainage pipe to discharge waste water.
- Application: Optical Hand Edger Manual Lens Grinder Can grind Resin,Glass,PC,Stone,Bit tool,etc.
When this machine is to be used, connet the hose with the adaptor of the lower water can. The place the lower water can onto the bottom of the machine(the water can run out either in the front or at the back)and lead the drain pipe to the sewer tunnel
Place the upper water can on the top of the machine and let in the clean water. When the machine is used for the first time, take the sponge out from under the water valve, put it into the water, press it with your hand and the put it back in its original place after it absorbs enough water. Open the water valve and let the water drip at 80-100 drops a minute. Then turn on the switch. The machine is ready to be used.
If Model W grinding wheel is choosen, the right side will be rough ground ,and the left side fine ground. When Model WV grinding wheel is chosen the result with be the same, but there is also a V-shaped solt to refine the lens
After the machine is used for a period of time, take the lower water can out and clean it in case the draining hole should be blocked.
When the grinding wheel has been used for a period of time, grinding fatigue will appear(failing to grind in).In this case, use the oilstone stick to recondition the wheel. While this is being done, open the water valve
The reversible button on the left side of the machine is a backward or forward adjustor(not used often).When it is required to run in normal direction or opposite direction, the chief power switch should be turned off or machine will be damaged.
Item Included
1 set of 110v Hand edger Manual lens edger (153003)
Country USA
Brand TECHTONGDA
Manufacturer CN
Binding Tools & Home Improvement
ItemPartNumber 43237-2
Model 43237-2
Color White
UnitCount 1
UPCs 754610407932
EANs 0754610407932
ReleaseDate 0000-00-00

Country	USA
Brand	TECHTONGDA
Manufacturer	CN
Binding	Tools & Home Improvement
ItemPartNumber	43237-2
Model	43237-2
Color	White
UnitCount	1
UPCs	754610407932
EANs	0754610407932
ReleaseDate	0000-00-00

TECHTONGDA Lens Grinder Hand Lens Edger Eye -Glasses Hand Edger With V-groove 110V Manual Lens Edger Polisher Grinding Single Wheel Grinder Optical Hand Stone

You might also like...