VXDAS 3in1 Auto Tire Pressure Monitor Sensor TPMS Relearn Reset Activation Tool OEC-T5 for GM &Toyota Series Vehicle

1.Most of Ford vehicles equipped with a 315 or 433 MHz (TPMS) Tire Pressure Monitoring system,.a "Sensor Re-Learn Procedure" must be performed after tire rotations
2.Remote Control Door Lock Receiver Module replacement or Tire Pressure Sensor replacement.
3.This re-learn procedure can be performed by using EL-50449 special tire pressure tool
4.EL-50449works on 2014 Ford models too.


Step 1 - Enter leaning mode

Set the gearshift lever to "P"
Put the ignition switch to "ON"
Enter the interface of tire pressure display by DIC
DIC shows "Press Set / Ctrl to re-learn"
Press "Set / Ctrl"
The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode


Step 2 - Read tire pressure sensor information

Start from the front-left wheel,
Make the J-46079 or Diagnostic Tool EL-50449 antenna up against the valve core position & close to the rim of the tire sidewall
El-50449 tire pressure tool starts by the start switch
Successful to read the tire pressure sensor information when the horn bleeps once


Step 3 - Same method to read other tire pressure information

Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels.
Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete.