eSUN 3D Printer bio Resin for LCD 3D Printers, 500g eResin-PLA

eSUN 3D Printer bio Resin for LCD 3D Printers, 500g eResin-PLA Clear
- Environmental protection
- High precision
- High hardness and scratch resistance
- Good moisture-resistance performance
Product: eSUN PLA Photopolymer Resin for LCD 3D printers, eResin-PLA
Size: 500ml
Color: Clear

Packaged in a durable aluminum bottle

Parameters:
Solidify wavelength: 395nm to 405nm
Hardness (D): 75D
Viscosity (25C,mPa.s): 250 to 350 mpa.s
Density: 1.10 to 1.11 g / cm3
Shrinkage of Vol.: 5.52%-5.97%

Physical Properties:
Flexural strength (Mpa): 50Mpa to 55Mpa
Flexural Modulus (Mpa): 1.61 to 2.56
Tensile strength (Mpa): 40Mpa to 50 Mpa
Elongation at break (%): 32% to 40%
Notched impact strength (J/m): 90 to 97
Hardness (D): 75D

Precautions:
1. Storage
1) Keep away from light and sealed at room temperature.
2) It is recommended to store the resin between 15 Celsius and 35 Celsius in its original container.
Avoid any dusty or moist environment.

2. Usage:
1) Shake well before use. Avoid any direct sunlight during usage.
2) Keep it away from the children. Do not put in mouth.
3) Wear gloves before use to avoid direct contact with the skin and keep the room ventilated.
4) If accidentally contacted, please wash with plenty of water immediately. Seek medical advice if necessary.
5) Finished models are required to clean by high-concentration alcohol (>95%) about 30 seconds.

Before choosing eSUN resins for your LCD 3D printers, please confirm that the UV wavelength of your 3D printer is 405nm. Thoroughly tested and perfectly compatible to EPAX X1, Anycubic Photon and Wanhao D7.

Bottom Exposure Time: 30-50s when layer thickness is 0.05mm, recommend set to 40s.
Normal Exposure Time: 6-10s when layer thickness is 0.05mm, recommend set to 7s on EPAX X1 or 10 seconds on Anycubic Photon.
PS: Exposure time is proportional to layer thickness. The numbers above are for layer thickness 0.05mmã€‚if thickness is 0.1mm, the normal exposure time will be 12-20s. If layer thickness is 0.02 then the normal exposure time is 2-4s.
Country USA
Brand eSUN
Manufacturer eSUN
Binding Health and Beauty
ItemPartNumber ERESIN-PLACLEAR05A
Model ERESIN-PLACLEAR05A
Color Clear
ReleaseDate 2020-03-16
UnitCount 1
UPCs 840249178302
EANs 0840249178302

Country	USA
Brand	eSUN
Manufacturer	eSUN
Binding	Health and Beauty
ItemPartNumber	ERESIN-PLACLEAR05A
Model	ERESIN-PLACLEAR05A
Color	Clear
ReleaseDate	2020-03-16
UnitCount	1
UPCs	840249178302
EANs	0840249178302

eSUN 3D Printer bio Resin for LCD 3D Printers, 500g eResin-PLA Clear

You might also like...