DIGITEN G1/2" Water Flow Hall Sensor Switch Flow Meter Flowmeter Counter 1-30L/min
Product Description
DIGITEN G1/2" Water Flow Hall Sensor Switch Flow Meter Flowmeter Counter 1-30L/min
- The Water Flow Sensor is light, nimble outline, small size and easy to install. The bearings used in the rotating part.
- There is an integrated magnetic hall effect sensor that outputs an electrical pulse with every revolution. The hall effect sensor is sealed from the water pipe and allows the sensor to stay safe and dry.
- Working voltage range: DC 3-24 V
- Output Waveform: Square Wave,output pulse signal.
- Waterproof, heat resistance, pressure resistance, cold resistance.
Waterproof,Heat resistance,pressure resistance,cold resistance.
Easy to install.
Outer diameter: about 0.79inch
Frequency: F=7.5 * Q (L / Min) error: ± 2% voltage :3.5-24VDC, current can not exceed 10mA, 450 output pulses/liters, F=onstant * units of flow (L / min) * time (seconds)
Flow range:1-30L/min
Maximum current:15 mA(DC 5V)
Working voltage range:DC 5-24 V
Load capacity:≤10 mA(DC 5V)
Operating Temp:≤80℃,Operating humidity:35%-90%RH
Allow compression:Water pressure 1.75 Mpa below
Insulation resistance:>100M OHM
Storage Temperature:-25-80℃
Storage humidity:25%-95%RH
Output Waveform:Square Wave,output pulse singal.
ROHS Compliant.
Cable length:15cm.
Packaging include
Flowmeter x 1
Note:The thread is BSP, if used for NPT, need thread seal tape.









