Plastic Mold for 3D Decor Wall Panels #13, for Plaster

Plastic Mold for 3D Decor Wall Panels #13, for Plaster (Gypsum) or Concrete
- - Really easy to make by your own! Our molds the best way to save money and have unique interior!
- - Endures fills 200+ you can cover 520+ sq ft with only one mold!
- - Unique design
How to make 3d panels? 1. Not necessary (but recommended). Make a frame (wooden is ok) under the mold so that you can tightly fix your mold on the surface. 2. Lubricate the mold (especially in deep places and corners). You can use special greases or something like vaseline (petrolatum). 3. Make mixture with ratio shown in the spreadsheet at the top and fill the mold. Tap the mold slightly several times to remove air from mixture. 4. After about 3-5 min you can feel that plaster got warmer, after this wait about 15 min and bend the edges one by one, carefully turn the mold upside down and take it off from panel. 5. Look at the panel edges and remove bevels with putty knife if they appeared. 6. Leave panel to dry in a warm place (face side down or in vertical position) 7. Also you can already mount them on wall without waiting for drying because gypsum does not shrink.
Country USA
Brand Form Master
Manufacturer Molds and Stamps
Color Black
Size Length 50 cm /19.6 in Width 50 cm /19.6 in
UPCs 689756404098
EANs 0689756404098
ReleaseDate 0000-00-00

Plastic Mold for 3D Decor Wall Panels #13, for Plaster (Gypsum) or Concrete